![]() Goptions reset=all cback=white border htitle=12pt htext=10pt Īxis2 label=(angle=90 "Value") minor=(n=4) order= 0 to 1 by. The options in the ODS GRAPHICS statement are global to the SAS session. How can I fix it so that I can match my regression line properly with the plot without adding another axis? /* Set the graphics environment */ You file is created in the directory from where the Workspace Server is started on the UNIX server. ![]() ![]() If I use the same horizontal and vertical axis (axis1 and axis2 respectively) as the option for plot2 instead, then I end up with another axis on the right side of my plot as shown in the picture below. The problem is that if I specify the noaxis option for plot2, then then the regression line does not fit properly to my points anymore. If no syntax error is detected, a compiled template named MODELFIT is created and stored in the Sasuser.Templat item store by default. I had to adjust the range of the y-axis (axis2) in order to fit the range of values I was interested in (used order option to accomplis this). For the situations where your code tries to use a procedure which is not licensed (or installed) the log will show a similar ERROR: message. I am trying to create a plot using proc glpot. There are four ways to create biplots in SAS by using ODS statistical graphics: You can use PROC PRINQUAL in SAS/STAT software to create the COV biplot. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |